Jump to content

Mpollard

Member
  • Content Count

    18
  • Joined

  • Last visited

About Mpollard

  • Rank
    New Member

Profile Information

  • Region
    Decline
  • Location
    Sc
  • Current Vehicle
    99f250 5.4

Recent Profile Visitors

23 profile views
  • ET1

  1. Mpollard

    P0016

    Yes chains were right. I’m going to use the cheese wedge thing and change the phasers if that’s not it I guess I’ll dig back in and check timing
  2. Mpollard

    P0016

    What are chances of the bad phaser
  3. Mpollard

    P0016

    I can also unplug the solenoids and cam sensors with no change in running. Oil pressure on gauge actually shows a little high
  4. Mpollard

    P0016

    I took the back of the phasers off to look for broken vanes inside. Leaving one screw in that holds apring tension The chains had three black links in them. When I took it apart it had blew a head gasket. I put 12 volts on the vvt solenoid and it moves free. The phaser is the only thing I can think of. Since it was showing this code before and after. Would a bad phaser on passenger side make it run rough at idle and be hard to start? When I turn the phaser bolt the front of the phaser will turn a little. Is that normal? I just don’t want to tear it down change phaser and then have to do it again to time it again
  5. Mpollard

    P0016

    My 07 expedition had code p0016 in it. I tore it down put new chains guides and tensioners in it put it back together fires it up and still has this code. I swapped cam sensors and vct solenoids but still has code. Hard to start and rattles when started for a second. Could this be phasers? It idles rough too
  6. Mpollard

    99 f250 5.4 codes

    All wiring looks good idk what else to do
  7. Mpollard

    99 f250 5.4 codes

    All wiring looks good idk what else to do
  8. Mpollard

    99 f250 5.4 codes

    Just a cornwell code reader I'm going to re check all wires and make sure they not rubbing
  9. Mpollard

    99 f250 5.4 codes

    If I have the top ground to the intake manifold is that ok? It has a aluminum intake
  10. Mpollard

    99 f250 5.4 codes

    What is rfi? Never heard that one
  11. Mpollard

    99 f250 5.4 codes

    Feels like a bad misfire like it's running on 2 cylinders and it does t matter if under a load or not
  12. Mpollard

    99 f250 5.4 codes

    Happens hot and when driving. No matter if u running 40 or 80
  13. Mpollard

    99 f250 5.4 codes

    Codes come back as soon as it sputters for that second but then it straightens up. Could a bad crank sensor or iat sensor cause this? Maybe a cam sensor
  14. Mpollard

    99 f250 5.4 codes

    If it was one tooth off wouldn't it run bad all the time?
×